Common drain valve

The common mud valve is JM744X hydraulic Angle quick opening mud valve, JM644X quick opening mud valve, 100S Angle type mud valve, JM742X diaphragm bottom mud valve and so on.

1. JM744X hydraulic Angle quick opening mud valve

JM744X hydraulic Angle type quick opening mud valve, is a kind of hydraulic source or pneumatic source as the actuator Angle truncation valve. Usually installed in rows on the outer wall of the bottom of the sedimentation tank to remove mud and sand and dirt deposited at the bottom of the tank.

The valve is divided into two chambers by the mud dragon strengthened rubber diaphragm. The hydraulic or pneumatic source is connected, and the electric or manual two-position four-way directional valve is used to control the fast mud discharge. The valve will be diaphragm instead of piston, no motion friction, more suitable for mud and other granular media, greatly improve the service life of the valve.

JM744X Hydraulic Angle quick opening mud valve before the installation of the filter, and should be convenient for sewage requirements.

2.JM644X quick open mud discharge valve

JJM644X Quick discharge mud valve is usually installed in rows on the outer wall of the bottom of the sedimentation tank to remove the sediment sand and dirt at the bottom of the tank. The valve is divided into two chambers by nylon reinforced rubber diaphragm, connected with hydraulic or pneumatic source, and controlled by electric or manual two-position four-way directional valve to achieve rapid mud discharge. The valve will replace the diaphragm piston without motion friction, more suitable for mud and other granular media, greatly improving the service life of the valve.

3. 100S Angle type mud discharge valve

100S Angle diaphragm mud discharge valve is a kind of Angle diaphragm cut-off valve. Usually installed at the bottom of the settling tank in sewage treatment plants to remove mud and dirt settling on the bottom of the tank. Inside the valve is nylon reinforced rubber diaphragm, and designed for Angle structure, using the smooth removal of dirt, easy installation, long service life.

Main parts and materials

4. JM742X diaphragm bottom sludge valve

JM742X diaphragm bottom sludge valve is composed of main valve, two four with the valve and valve disc and other parts. When two four-way directional valve in a state position, the main valve in the chamber of water, the upper chamber to the atmosphere, the diaphragm under the pressure of water to drive the valve disc up, the main valve open, the bottom of the sediment and other sewage began to discharge; When the two four in the two state position, the main valve chamber water drainage to the pool, the upper chamber water, close the main valve, stop the discharge of sediment. The valve is installed outside the bottom wall of the sedimentation tank to remove sediment from the bottom of the tank. It is controlled by reversing valve opening and closing action, quick response, accurate closing.